5 Ways to Repair a Fan
The use of a fan that is too frequent, often makes the fan problematic. One of the many problems with a fan is that the fan is totally dead. This can be overcome by ways of repairing the fan below:
1. Vibration at the Dynamo of the Fan Lost
A fan that will die completely usually starts with a slow spinning fan wheel. This slow rotation can be caused by the large amount of dust that sticks, but the owner of the fan is reluctant to clean it. The dust sticks mainly to the rotor shaft or the fan shaft. For this reason, before you learn how to repair a fan, you better avoid damaging the fan by cleaning it often. But if this is not the case, then you can apply the method to repair the fan below:
2. Checking the Cable Section
The first way to repair a fan is to check the power cable section. In this section you have to make sure there are broken parts or not. To check this section, you need a multimeter or AVO meter tool. If the cable is broken, you must immediately replace it with a new one. If not, then you must do further examination.
3. Check the Settings Button Panel
You must check the fan speed rotation speed button. This check can be done using a multimeter or AVO meter on each cable connection connected to the panel. Usually, there are two to three cables connected to the fan dynamo, and one cable from the source of the electric current.
When checking, make sure you position the AVO meter switch at x1 or x10 values, then attach the probe to each cable connected to the dynamo alternately. If the needle moves to the right, this can mean that there is still a connection and the condition of the fan coil is still in good condition. However, if it does not move, it can be ascertained that there is damage or broken parts inside the coil. Possibly the broken or broken part can be located on the fuse or thermofuse, or it can also be in the coil wire. If no connection is created, then proceed to the next step.
4. Unloading the Fan Dynamo
Another way to repair another fan is to check the connection on the panel, because there might be a broken cable in the armature. For this reason, the fan dynamo must be disassembled first. After that, look for the fuse or thermofuse that might break. This examination is carried out using a multimeter or AVO meter with the position of switches x1 or x10 and place it on both probes of each leg.
If there is no movement at all, the thermofuse can be broken or broken. If this is the case, then the thermofuse must be replaced with a new one. When this new thermofuse is pointing to the right, it means that the condition can still function properly. When you have replaced the thermofuse, the next step is to reinstall the fan dynamo and get the dynamo close with the bolt.
5. Check Fan Capacitors
Check the fan capacitor section. Because, weak capacitors will only cause the fan to spin slowly. The form of the capacitor is generally a black box. It is on the back of the dynamo. To find out if the capacitor is damaged or not, you can see it from the physical form of the capacitor. Capacitors that are not functioning or damaged, it will appear bloated, swollen and can also rupture. If it looks damaged, the capacitor must be replaced with a new capacitor immediately. All components must be examined carefully and sequentially when the fan is completely dead. Because, the cause of the fan is totally dead can vary.
This is how you can repair a fan that you should pay attention to. Maybe for those of you who have not repaired the fan before it will be a little difficult when doing it. You must examine each component carefully.
Of course repairing will save you more than you buy a new fan. Especially if it turns out the damage experienced by your fan is not much. For this reason, there is no harm in trying to repair a damaged fan. How? Are you ready to fix it? Good luck.